Author Topic: Cellaret Plans  (Read 4883 times)

BarryDaniel

  • Forum Apprentice
  • *
  • Posts: 17
Cellaret Plans
« on: November 24, 2007, 09:08:47 PM »
Does anyone have good drawing or plans for a cellaret? I would like to make one about a 2/3 as long as a sideboard (30" or so) Most of the ones I have seen are rather short squat pieces, whereas I would (or should I say the Boss (wife)) like it to be about 35-40" at the table top. Any help would be appreciated.

Barry

Tom M

  • Forum Master
  • ***
  • Posts: 168
Re: Cellaret Plans
« Reply #1 on: November 24, 2007, 10:01:55 PM »
I'm 99.9% done with a drawing for Olde Mill of Gene Landon's Philadelphia Cellaret.  I should have it to Bess in the next couple weeks - just making some view changes per a request from Gene.  Gene's cellaret is an 18th century piece with major restoration.  The piece is about 33 high x 24 wide x 17 deep. See picture of Gene's.
Tom Meiller, SAPFM Member #684

pampine

  • Forum Master
  • ***
  • Posts: 111

NLandry

  • Guest
Re: Cellaret Plans
« Reply #3 on: November 26, 2007, 02:49:31 PM »
Pam,

The Carlyle Lynch measured drawings are now available directly from his daughter, Janet, on line at www.CarlyleLynch.com.

pampine

  • Forum Master
  • ***
  • Posts: 111
Re: Cellaret Plans
« Reply #4 on: November 27, 2007, 07:16:35 AM »
Thanks, Norman, I didn't know that.

Pam

BarryDaniel

  • Forum Apprentice
  • *
  • Posts: 17
Re: Cellaret Plans
« Reply #5 on: November 29, 2007, 10:54:45 PM »
Thanks to all of you for the suggestions. I actually found a Carlyle Lynch plan in finewoodworking for a small queen anne dresser. I think this will find my need just fine. With the one found I will modify and put doors on the upper cabinet instead of drawers. That should look good.

Barry