Author Topic: Stanley 112 scraper  (Read 97 times)

macchips4

  • Forum Master
  • ***
  • Posts: 167
Stanley 112 scraper
« on: February 01, 2019, 08:00:43 PM »
      Kind of slow on the forum/site lately so I thought I would ask opinions......Using a Stanley 112 scraper plane with a Stanley toothing blade for preparing the surface for veneer...which blade to get.....22, 28 or 32 teeth?
     Any thoughts? I've been getting by, using part of a hack-saw blade, scraping by hand. 

The Cabinetmaker

  • Forum Apprentice
  • *
  • Posts: 19
Re: Stanley 112 scraper
« Reply #1 on: February 07, 2019, 07:31:22 PM »
I remember reading that for toothing planes the coarse blades were for leveling a surface whereas the finer ones were for veneer work.

Mark Maleski

  • Regional Chapter Coordinator
  • Forum Master
  • ***
  • Posts: 188
Re: Stanley 112 scraper
« Reply #2 on: February 08, 2019, 04:43:39 PM »

I have an old English wooden toothing plane (Buck 242, made sometime between 1880 and 1930) with a Ward iron.  The teeth were done by hand before hardening.  There are 18 tpi, which I've always considered fairly fine.  Your post and the follow-up have me reconsidering that.  BTW, my Lie-Nielsen toothing blade, which is marketed solely for leveling, has 15 tpi and seems considerably more coarse.


I haven't seen replacements toothing blades for the 112...can you share a source (merely out of curiosity...I don't even have a 112!)