Author Topic: Carnauba wax under shellac  (Read 1062 times)

Joseph Redgate

  • Forum Apprentice
  • *
  • Posts: 4
  • Joseph Redgate
Carnauba wax under shellac
« on: July 07, 2014, 04:29:28 PM »
Good afternoon, gentlemen.

I was experimenting with filling heavy oak grain by using a hot iron to melt carnauba wax into it, then using a card scraper to remove the excess, and finally finishing with dewaxed shellac.  I used a 3x5 piece of red oak from a home center and it seems to be working beautifully.  Does anyone see future problems that might arise?  Can this be a viable solution to filling oak, or will the shellac eventually lift off of the carnauba?
« Last Edit: July 07, 2014, 04:42:55 PM by Joseph Redgate »
Sincerely and respectfully,
Joseph Redgate

R Bohn

  • Forum Master
  • ***
  • Posts: 112
Re: Carnauba wax under shellac
« Reply #1 on: July 08, 2014, 11:14:12 AM »
Hi Joseph
 Although shellac can be applied over wax it's not a good practice. Wax in the pores will prevent the shellac from penetrating into the wood as well as it could and could cause finish adhesion problems in the future. Especially if the surface is exposed to heat. A better process is to fill the pores with  a pore filler or as I do, fill the pores by French Polishing using a little pumice.
 Experimenting is cool!!  Keep asking questions.
 Randy
Restoration and Conservation of Fine Antiques Serving Museums, Dealers and Private Collectors Nation wide since 1979