Author Topic: Knee Blocks  (Read 1988 times)

HSteier

  • Forum Master
  • ***
  • Posts: 294
Knee Blocks
« on: December 24, 2012, 04:25:36 PM »
As I was sawing out eight knee blocks for an oval stool I began to wonder what would be the best way to smooth the sawn surfaces? I ended up using a file and sandpaper-very tedious. I know the sawn surfaces are not in plain sight, but nevertheless they are pretty rough when they come off the bandsaw. Any suggestions? Should I even bother trying to smooth them? Whar about antiques pieces? Were they left rough?

Howard Steier

jim vojcek

  • Forum Master
  • ***
  • Posts: 126
Re: Knee Blocks
« Reply #1 on: December 24, 2012, 06:24:22 PM »
I use a fine rasp, then sandpaper.   

Jim Vojcek

Jack Plane

  • Forum Master
  • ***
  • Posts: 223
  • UK antiques dealer, now residing in Australia.
    • Pegs and 'Tails
Re: Knee Blocks
« Reply #2 on: December 25, 2012, 01:24:48 AM »
If the marks have been left by a bandsaw, they I use a rasp to disguise the majority of the parallel tracks. If the marks are the result of hand-sawing, then I only use a rasp to fair the bare necessities.
Regards, Jack.

Antiquity Period Designs, Ltd.

  • Forum Master
  • ***
  • Posts: 385
  • Professional period furniture maker
Re: Knee Blocks
« Reply #3 on: December 25, 2012, 08:47:51 AM »
I will use a chisel and gouge to remove the band saw marks. Some knee blocks were also held on with a cut nail.

Dennis Bork
Professional period furniture maker since 1985.  Received a B.S. degree in physics then apprenticed and worked as a wood patternmaker for 12 years. Retired Dec. 2018.