Author Topic: Relief Carving Bench  (Read 4727 times)

dlb

  • Forum Apprentice
  • *
  • Posts: 9
Relief Carving Bench
« on: December 15, 2012, 09:46:22 AM »
I am looking for suggestions regarding the best style of relief carving bench to build. I have seen Bill Judt's and am attracted to its features but wanted to check here first prior to purchasing his plans. Link here: http://wwwoodcarver.com/Home/TiltingCarversBenchPlans.html
Thanks,
dlb
.
« Last Edit: December 21, 2012, 09:55:33 PM by dlb »

marymaycarving

  • Forum Apprentice
  • *
  • Posts: 48
Re: Relief Carving Bench
« Reply #1 on: December 23, 2012, 11:30:27 PM »
The bench looks very interesting and seems like it can be used in a variety of ways. Here is what I recommend for relief carving - height should be about elbow height, or just below elbow height. Lower than this, you will need to bend over too much, and higher than this, you will strain your shoulders trying to lift yourself higher. The design looks like it has a lot of holes for bench dogs/hold-downs, which is great to have the flexibility of many ways to hold a piece. I have a carving bench that I purchased from Woodcraft about 10 years ago that has a top that tilts (as in the design). However, I have never used the table tilted. I find that working flat, I put a lot of my weight into the carving, and if it were tilted, completely different muscles are used. I would guess you could continue to put your weight into the carving up to about a 45 degree angle, but when it goes more vertical, it's a whole different process. I have had to do carvings on a vertical surface and because my muscles have not been trained for this, I was exhausted after about an hour.

Just some thoughts. Happy carving!


jim vojcek

  • Forum Master
  • ***
  • Posts: 126
Re: Relief Carving Bench
« Reply #2 on: December 24, 2012, 06:32:19 PM »
I use my standard work bench which is about elbow height.  For holding the matrerial, I use bench dogs and holdfasts. 

Jim Vojcek